Start by cutting two 2x4s to 89" tall and screwing them to the wall 121⁄2" apart. This height was chosen to just fit under the tracks of our garage door. Make use of the full amount of available vertical space by adjusting the length of your 2x4s to suit the height you have. The boards are fastened with their wider face against the wall. With the 121⁄2" space between them, you should be able to screw both boards directly into wall studs, which are typically set on standard 16" centres. (See "Weigh Anchor" on page 66 for tips.) Be sure to pick the straightest 2x4s you can find for this application. Use a 4' level to ensure that they are perfectly vertical as well as parallel to each other. The spacing between these boards affects the dimensions of all the modules, so if you change this figure, you will need to adjust the other measurements to fit.
Module 1: Scooters
The scooter storage module is inspired by bike storage racks where the wheels are trapped in the gap between sets of two boards. There are also right-angle notches for the front wheels, which let you store scooters with their handlebars turned in. This set-up allows you to fit scooters very close together, yet still have them easily accessible.
Before constructing this module, check the dimensions against your own fleet of scooters to see if any adjustments are necessary. Scooters vary in length, wheel size and in how flat the underside of the deck is. This last feature affects how steady the scooters will stand in the module.
Cut six 3⁄4"-thick deck boards to 3" x 29" and three pieces of 2x4 to 21". Measure 3" back from the front of each board and cut a 11⁄2" x 13⁄16" notch. This notch is for the front wheel to turn sideways for tight storage. The boards are positioned in pairs, 1" apart, with the notches facing in to receive scooter wheels. (The notches need to be wider than 1", as the front wheels tilt back at a slight angle.)
Screw or nail the deck boards down onto the three 2x4 support boards. The front and back 2x4s provide enough strength to support the scooters. The third 2x4 section is positioned 12" back from the front. This support acts as insurance against the efforts of rambunctious kids who invariably step and jump on everything in sight.
One option to consider is cutting a pair of 3⁄4"-deep rabbets in the rear 2x4 support board to fit around the two vertical 2x4s of the organizer. These notches help lock things together tightly and pull the scooter module just a bit tighter against the wall. If your garage is like mine, even an extra 3⁄4" of space is welcome. If you choose to do this step, you will want to cut the rabbets before you assemble this module, then cut the deck boards to match.
Module 2: Skateboards
Supporting a skateboard is quite simple. They tuck nicely into the low space behind the scooters, requiring only a horizontal support arm at each end. For each skateboard, cut two arms 10" long by 3" wide. Use a jigsaw or bandsaw to taper the arms so they narrow to 11⁄2" tall at the front, then fasten them to the inside edges of the vertical 2x4s. The tapering ensures that the arms fit between the wheels on the skateboards. There are variations among skateboards, so measure yours to check these dimensions. The first set of support arms is positioned 5" above the scooter module. Each additional pair of support arms is positioned 1" above the previous pair.
0 Comment